APC AP9613 Instrukcja Instalacji Pobierz pdf (Strona 15)

Installation Manual

If neither of these servers is available, see “Device IP Configuration

Utility” on page 10, “Local access to the command line interface” on

page 12, or “Remote access to the command line interface” on page 13

to configure the needed TCP/IP settings.

BOOTP. For the Network Management Card to use a BOOTP server to configure

its TCP/IP settings, it must find a properly configured RFC951-compliant BOOTP

server.

In the BOOTPTAB file of the BOOTP server, enter the Network Management

Card’s MAC address, IP address, subnet mask, and default gateway, and, optionally,

a bootup file name. Look for the MAC address on the bottom of the Network

Management Card or on the Quality Assurance slip included in the package.

When the Network Management Card reboots, the BOOTP server provides it with

the TCP/IP settings.

• If you specified a bootup file name, the Network Management Card

attempts to transfer that file from the BOOTP server using TFTP or FTP.

The Network Management Card assumes all settings specified in the bootup

file.

• If you did not specify a bootup file name, you can configure the other

settings of the Network Management Card remotely through its Web

interface or command line interface; the user name and password are both

apc, by default.

To create a bootup file, see your BOOTP server documentation.

DHCP. You can use an RFC2131/RFC2132-compliant DHCP server to configure

the TCP/IP settings for the Network Management Card (NMC).

This section summarizes the NMC’s communication with a DHCP

server. For more detail about how a DHCP server can configure the

network settings for a Network Management Card, see the NMC User’s

Guide on the Utility CD or on the website.

1. The NMC sends out a DHCP request that uses the following to identify

itself:

– A Vendor Class Identifier (APC by default)

– A Client Identifier (by default, the MAC address of the NMC)

– A User Class Identifier (by default, the identification of the

application firmware installed on the NMC)

DMP IM 990-3404.book Page 11 Monday, March 11, 2013 9:05 AM

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 35 36

Brak uwag

APC AP9613 Instrukcja Instalacji Strona 15