APC Network Management Card AP9617 Dokumentacja Pobierz pdf (Strona 6)

2 Installation and Quick Start

How to Avoid Equipment Damage

Use bypass

mode for

Matrix-UPS

Matrix-UPS. Before you install the Management Card, put the

UPS into bypass mode to continue to provide power to the

load:

1. Loosen the

thumbscrew



the center of the

back of the UPS to

remove power

from the

electronics unit,

which contains the

slot



for the

Management

Card. The

isolation unit (the part of the UPS below the

thumbscrew) continues to provide power to the load.

2. Install the Management Card.

3. To restore power to the Electronics Unit, taking the UPS

out of bypass mode:

a. At the back of the UPS, tighten the thumbscrew



b. At the front of the UPS, press any one of the three

buttons below the LCD on the Electronics Unit. Then

respond to the prompt to take the UPS out of bypass

mode.

For instructions, see “Installation in a UPS”

on page 6.

1 2 3 4 5 6 7 8 9 10 11 ... 31 32

Brak uwag

APC Network Management Card AP9617 Dokumentacja Strona 6