
NetShelter SX Enclosure: Unpacking, Installation, and Customization18
Adjusting the vertical mounting flanges on the side braces
Warning: To avoid personal injury or damage to the enclosure, perform this procedure
without any equipment installed on the mounting flanges.
1. Use the Torx T30/#2 Phillips wrench (provided) to loosen—but not remove—the Torx screws in
the slots of each mounting flange.
2. Lower the flat bracket and move the mounting flange to the desired location.
600-mm enclosure
750-mm enclosure
Komentarze do niniejszej Instrukcji