APC PD80G6FK1-M Instrukcja Obsługi Pobierz pdf (Strona 34)

26 InfraStruXure System – Service Manual – Installation and Start-Up 990-1467C

Connect AC Power and Control Wiring

Note: Before you connect AC power and control wiring, connect utility conductors to the

PDU. For instructions, see Certified Electrician’s Instructions included with the PDU

documentation.

Electrical Hazard: Only qualified personnel trained by APC may connect the AC

power and control wiring.

Attach AC power and control wiring to the UPS. The power wires are coiled in the bottom of the

PDU. There are five main input wires, four bypass input wires, and four output wires coiled on the

floor of the PDU. Each set of wires is labeled. The control wires for the UPS Maintenance Bypass

control board and the UPS EPO control board are also coiled in the PDU. The diagram below

provides an overview of the connections that you will make between the PDU and the UPS.

To make the connections you will need to remove the rear lower panel of the UPS and the rear panel

of the PDU. Use the opening in the side panels of the enclosures to run the wires.

Input

Bypass

Output

Maintenance Bypass Control

EPO Control

PDU

UPS

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 95 96

Brak uwag

APC PD80G6FK1-M Instrukcja Obsługi Strona 34